Basic info.

Each 1ml TMT Blend 500 semimade steroid solution contained:

Trenbolone Enanthate 250mg

Drostanolone Enanthate 250mg

Semi-made means that all you need to do is just sterilizing the solution, such as filtration with 0.22 micron pore filters, then they are ready for use.

How do we make sure quality of TMT Blend 500?

The steroid powders of our company is produced according to the United States Pharmacopeia standard.

Every batch of powder is tested by HPLC equipment by our lab QC. We are offering products only after we make sure them are good.

We have return policy. If the quality is not satisfied after your testing there, we will return your funds within 1 working day.

How to inject TMT Blend 500?

All oil based and water based anabolic steroids should be taken intramuscularly. This means the shot must penetrate the skin and subcutaneous tissue to enter the muscle itself.  

Intramuscular injections are used when prompt absorption is desired, when larger doses are needed than can be given cutaneously or when a drug is too irritating to be given subcutaneously. The common sites for in tramuscular injectons include the buttock, lateral side of the thigh, and the deltoid region of the arm. Muscles in these areas, especially the gluteal muscles in the buttock, are fairly thick. Because of the large number of muscle fibers and extensive fascia, (fascia is a type of connective tissue that surrounds and separates muscles) the drug has a large surface area for absorption. Absorption is further promoted by the extensive blood supply to muscles. Ideally, intramuscular injections should be given deep within the muscle and away from major nerves and blood vessels.

The best site for steroid injections is in the gluteus medius muscle which is located in the upper outer quadrant of the buttock. The iliac crest serves as a landmark for this quadrant. The spot for an injection in an adult is usually to 7 1/2 centimeters (2 to 3 inches) below the iliac crest. The iliac crest is the top of the pelvic girdle on the posterior (back) side. You can find the iliac crest by feeling the uppermost bony area above each gluteal muscle. The upper outer quadrant is chosen because the muscle in this area is quite thick and has few nerves. The probability of injecting the drug into a blood vessel is remote in this area. Injecting here reduces the chance of injury to the sciatic nerve which runs through the lower and middle area of the buttock. It controls the posterior of each thigh and the entire leg from the knee down. If an injection is too close to this nerve or actually hits it, extreme pain and temporary paralysis can be felt in these areas. This is especially undesirable and warrants staying as far away from this area as possible.

we also offer premixed Steroid solutions which need only filter before Inject, such as:

- Test Enan 300 mg/ML, Tren Ace 100 mg/ML,Tren Enan 200 mg/ML,Deca 300 mg/ml, Masteron Prop 150 mg/ml,Boldenone Undecylenate 300 mg/ml,Stanozolol Suspension 50 mg/ml,Supertest 450 mg/ml,Sustanon 250 mg/ml, Anomass 400 mg/ml, Cut Stack Depot 400 mg/ml, Rip Cut 175 mg/ml, etc…

the way for you to get finished injectables is to sterilize the solutions, such as filtrating the solutions by 0.22μm or 0.45μm syringe filter or vacuum filter devices. 

you can get the syringe filter and vacuum filter from us also.